Rémy Vidali Posted December 3, 2022 Posted December 3, 2022 (translated by deepl) Hello, I am calling for help. I bought the TCA Quadrant to complete the TCA officer pack airbus. To complete my equipment, I have been using the rudder from saitek for years. I mainly use Fslabs buses and I am on P3d v4. The problem is this: When I deploy the spoilers, the rudder also acts. On deployment: full right. When retracting, full left... I have to check in the following parts : - key assignments : no key assignment for the different rudder for the "saitek pro flight rudder pedal" and for the "tca Q-Eng" ; - axis assignments : the "tca Q-Eng" uses the Rz axis for the spoilers but the problem is that the "saitek" also uses an Rz axis. - after a new test consisting in deleting all the key assignments (including slew) in the "axis" part, the result is the same. - similarly, by deleting all the "axes" in P3d and programming them in the "input" part of fslabs, the result is the same. So, in flight when I have to deploy the spoilers, it works for this system but the rudder moves too. I have to put "foot" to center the rudder. I tested it on the road and it's the same thing. If I remove the Rz axis for the "saitek" I no longer have control of the rudder. However, the action of deploying the spoilers still controls the saitek rudder. I have tried to find a solution to this problem but I am still stuck. Thank you for your help!
Norman Blackburn Posted December 3, 2022 Posted December 3, 2022 Hello Rémy Sadly no product support is offered in General Forum. There is s wonderful series of posts about TCA hardware in our A320 sub forum. Please check it out for more information.
Recommended Posts