Hi,

I was wondering, if I assign my joystick axis via FSUIPC (for example the elevator), what's the difference between

- Send direct to FSUIPC Calibration --> Elevator

and

- Send to FS as normal axis --> Elevator set
 

Both ways are working and seem to be influenced by what I then set on the Joystick Calibration tab (curves etc.).
So what's the difference, and is there a right way to do it?

Thanks

 

I think it's only relevant if you have devices with some nonstandard output range of values. May be it was more important in times where "raw" input was standard.

Gesendet von meinem Pixel 3 mit Tapatalk