MSFS | Skalarki | HWI | Random initialization of knobs and push buttons

[RUIZ Christopher]

Hello, 

I am testing the HWI for Skalarki on MSFS 2020 / 2024. For now I have to say that it's working super fine, thanks a lot.

Only issue that I have is that it seems that, when starting a new flight, when I press "connect to hardware" with plane on C&D, my panels PUB and knobs randomly initiate. Sometime adirs PB are off, strobes or other lights switch to on, packs might be off etc... It takes a little bit of time at each flight to check if there is no issue.

Most of the time, everything gets back into order (even if it would be better if it was more stable ) . Only remaining issue is with the 100/1000 switch on the glare shield alt selection knob. If physically my selector is on "1000" but the init put it on "100", then I will never be able to sync it. Putting it physically to 100 will switch it to 1000 on the aircraft and so on.

For info, I have MCDU, Radio, ATC, Glare, Mini OVH.

For now this init issue only hapenned with glare and mini ovh

[Fabian Schankin]

18 hours ago, RUIZ Christopher said:

Most of the time, everything gets back into order (even if it would be better if it was more stable ) . Only remaining issue is with the 100/1000 switch on the glare shield alt selection knob. If physically my selector is on "1000" but the init put it on "100", then I will never be able to sync it. Putting it physically to 100 will switch it to 1000 on the aircraft and so on.

Hi Christopher,

Baro unit and 100/1000 selector don´t synchronise at the moment. If you experience a mismatch for those selectors, please click the corresponding selector in the VC, that should realign the positions.

[RUIZ Christopher]

Gotcha ! I'll check your solution. But this issue is the leas problematic I'd say. 

The initialization of the cockpit state is more a thing I'd say.

 

[Fabian Schankin]

After loading the plane dark and cold at the gate, please wait a little before starting to connect the HWI. The plane takes a few seconds to load completely, also wait a little after connecting MSFS.

In Skalarki Profiler settings do you ticked "Cold and Dark Startup"? If not please do so and see if that is changing anything