Jump to content

FSL axis calibration utility - single throttle axis


M_i_k_e_V_o_g

Recommended Posts

M_i_k_e_V_o_g

Is there any way to assign both throttles to a single axis using the FSL calibration utility?

I can't seem to be able to assign the same hardware axis to both throttles.

Link to comment
Norman Blackburn
12 minutes ago, M_i_k_e_V_o_g said:

Is there any way to assign both throttles to a single axis using the FSL calibration utility?

I can't seem to be able to assign the same hardware axis to both throttles.

That element you would do in the MCDU.

Link to comment
M_i_k_e_V_o_g
On 11/24/2021 at 9:14 PM, Norman Blackburn said:

That element you would do in the MCDU.

The mcdu will set detent zones, not assign a hardware axis to the throttle. This is done by either the sims settings, fsuipc registered or the fslabs utility that’s available via the menu. Problem with the latter is that won’t allow the assignment of one axis to both throttles.

 

Link to comment
Norman Blackburn

image.png

Once this option is set then you only need to set a single axis within the sim, fsuipc or the FSL utility.

Link to comment
×
×
  • Create New...