Ferdi Vefa 2 Posted yesterday at 09:08 AM Report Share Posted yesterday at 09:08 AM In FSLabs Input command window Flaps and Speedbrake lever (Only arm switch available) assigment setups are missing. Is it techically not possible and should we try FSUIPC or standart P3D options. Regards :: Ferdi Link to post
Norman Blackburn 3377 Posted yesterday at 09:54 AM Report Share Posted yesterday at 09:54 AM 44 minutes ago, fvefa said: In FSLabs Input command window Flaps and Speedbrake lever (Only arm switch available) assigment setups are missing. Is it techically not possible and should we try FSUIPC or standart P3D options. Regards :: Ferdi Hi Ferdi, @fvefa Please change your forum name to be your real first and last names. Link to post
Ferdi Vefa 2 Posted 14 hours ago Author Report Share Posted 14 hours ago Sorry for the name changed it. I dont know if my TM-TQ Add-On works properly or not but Flaps lever has 4 detents but gives only one signal and thats the first one. So i used for Flaps FSUIPC. In manual on page 45 its expalined. Just a tip, dont forget to click middle SET button (for postions between zero and full) "twice" (assume incoming outgoing method for homecockpit users). Speedbrake has four detents (no pullout mechanism for arming. Would be nice) and gives four signals from 27-30. I reserved the first detent for "ARM" from FSLabs Input Command. Then from FSUIPC calibrated it starting from second detend to fourth. Regards :: Ferdi Link to post
Recommended Posts