Jump to content

Status Cat3 Inop


Arunit Mukherjee

Recommended Posts

Arunit Mukherjee

Before engine start, the status page shows Cat3 Dual in the Inop system. This must be a bug as in the real aircraft this appears only under MEL or if there is an actual fault. Normal the status should be normal before pushback.

Could you check.

Link to post
Darren Howie

We have it all the time in our aircraft.

It is caused by the auto tine tunng different ILS frequencies on the ground.

To get rid of the message hard tune the same ILS in both MCDU’s.

Boom mesage gone...well at least in the real aircraft...lol

  • Thanks 1
Link to post
Arunit Mukherjee

Hi Andrew, can we expect more fmgc features in the next update? Like etp,winds, rta,constant mach?

are you planning to Add more failures to the menu or only in the professional edition?

Link to post
Andrew Wilson

Hi Arunit - not to be included in the next update, but the missing features are being worked on. They will start being introduced after the release of the A319-X.

Link to post
Arunit Mukherjee

Hi andrew, off the topic. I was searching frantically for a fslabs approved hardware(ovhd panel, fcu, mcdu) for my home cockpit. Couldn’t find one. Any suggestions?

Link to post
×
×
  • Create New...